healeys
[Top] [All Lists]

[Healeys] Silly Question #7 - Thanks!

Subject: [Healeys] Silly Question #7 - Thanks!
From: dcorning at ford.com (Corning, Dan (D.C.))
Date: Wed, 21 Feb 2018 14:31:15 +0000
Thank you to everyone that responded!  Your descriptions and photos of your 
cars were very helpful.  I had a couple things routed wrong so with a few hours 
in the garage correcting them, I'll be back on track.

Thanks again,

Dan Corning


From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Corning, 
Dan (D.C.)
Sent: Monday, February 19, 2018 5:25 PM
Subject: [Healeys] Silly Question #7

I'm always struggling to find what goes where in my attempt to restore this BT7 
Mk II.  I spend hours Googling photos of various issues but this time, I 
decided to ask silly question number 7.

Regarding the pass-through holes in the bulkhead, I think I've run things 
through correctly for the most part.  To speed things up for the remainder, I 
thought I'd take a photo of my car and give each empty hole a number.  If you 
can provide guidance for the correct use of the holes I'd appreciate it.  I'm 
sure some if not most are not used and just need a blanking plug but I wanted 
to make sure before I install the engine.

I THINK holes # 1,2 & 3 are empty and should get a blanking plug.  Hole #4 and 
5 are where the engine temp sensor cable and choke pass through?  I have no 
idea what hole # 6 is for.  I ran the control for the cold air valve just above 
hole #7 but I'm not sure what 7 is for.

Lastly, Inside of the car I've seen several photos of what looks like the choke 
cable located UNDER the dash on the driver's side, often marked with a "C" on 
the knob.  For my car, Am I correct to run the choke control through the hole 
in the dash just above the cold air control?


Dan Corning



-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180221/fdf8a7ed/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>
  • [Healeys] Silly Question #7 - Thanks!, Corning, Dan (D.C.) <=