Dan
Did you see this? Go to David Nock, probably Kilmartin can make them a little
oversize for a BT7 as well, although it?s not in their catalog.
Per
Skickat fr?n min iPhone
Vidarebefordrat brev:
> Fr?n: "David Nock BCS" <healeydoc at sbcglobal.net>
> Datum: 13 februari 2018 17:53:00 CET
> Till: "Linwood Rose" <linwoodrose at mac.com>, "Per Schoerner" <per at
> schoerner.se>
> Kopia: <healeys at autox.team.net>
> ?mne: Re: [Healeys] BT7 Mk II Door Shut Finisher - Adjustment?
>
> The shut pillar trim that has come out of England has never fit the car
> correctly. We have used and supplied the ones the come from Kilmartin in
> Australia for many years and they always fit. They usually are a little big
> so they can be trimmed to fit your car.
>
>
> David Nock
> British Car Specialists
> 209-948-8767
> www.britishcarspecialists.com
>
> From: Linwood Rose
> Sent: Monday, February 12, 2018 5:01 PM
> To: Per Schoerner
> Cc: healeys at autox.team.net
> Subject: Re: [Healeys] BT7 Mk II Door Shut Finisher - Adjustment?
>
> As I recall, and I could be wrong because it was ten years ago, I had the
> same situation. The ill fitting set was from one of the usual vendors. I
> believe I ordered a set from Kilmartin and they were spot on. Check with
> Kilmartin and see if they sell them.
> Lin
>
> Sent from my iPad
>
>> On Feb 12, 2018, at 5:23 PM, Per Schoerner <per at schoerner.se> wrote:
>>
>> Dan
>> It looks like the shut panel can go a little bit further towards the center
>> of the car, there is a gap there. On the other hand it doesn?t look like it
>> will fit anyway. Do you still have the originals? So you can compare them.
>>
>> Per
>>
>> Skickat fr?n min iPhone
>>
>>> 12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com>:
>>>
>>> Everything was going very smoothly installing the new Bristleflex door
>>> seals and lower aluminum trim set. Too smoothly?
>>>
>>> A trial fit of the door shut finish set revealed the protrusion on the top
>>> is misaligned. Anyone experienced this before?
>>>
>>> (The dotted line suggests what I?m thinking about)
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180213/af9722bf/attachment.html>
|