my measurements match Bill's.
-Roland
BN1 #724
On Tue, 6 Feb 2018 05:33:40 +0000 (UTC), you wrote:
>Can someone look at their 100 and give me some kind of measurement location
>for the angled bracket that is welded between the trunk floor and the support
>hoop for the rear shroud.? The trunk lid lock does not line up with the
>striker in the trunk, so I can not lock the trunk.? I suspect during the
>restoration when the new hoop and bracket were welded in, the body man simply
>welded the bracket in the center.? I suspect it should be off center to the
>right a bit looking from behind the car for proper alignment.? The trunk lock
>is a fixed location with no adjustment.? The striker does adjust left and
>right some, but not enough to line up correctly.? I am not looking forward to
>removing the bracket and re-welding it since it has been painted already.Mike
>MacLean
>
>Sent from Yahoo Mail on Android
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
|