| To: | Rfbegani <rfbegani@speakeasy.net> |
|---|---|
| Subject: | Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle washers |
| From: | Perry <healeyguy@aol.com> |
| Date: | Thu, 1 Dec 2016 16:19:17 -0500 |
| Cc: | healeys@autox.team.net |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | healeys@autox.team.net |
| References: | <17896294.2153210.1479329366056.JavaMail.root@vms170025.mailsrvcs.net> <2939EC99-5EBA-4F67-A4D6-491760D8A850@speakeasy.net> |
The factory installed the rubber buffers on the shroud lip so that the hood / bonnet would have something to support it between the hinges and the front latch. If you don't see a small mark on your bonnet paint were the buffers are, chances are there is no support. Try laying a 1/16 inch thick piece or rubber (old inner tube) on top of the buffer and close the bonnet. See if the hood still shakes. It may take two. When the buffers are in contact the bonnet will not shake side to side. Permanent solution is to properly install the buffers. Perry Sent from my iPhone > _______________________________________________ Archive: http://www.team.net/archive Healeys@autox.team.net http://autox.team.net/mailman/listinfo/healeys |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Healeys] Chrome Plater SoCal Area, David Nock BCS |
|---|---|
| Next by Date: | Re: [Healeys] Chrome Plater SoCal Area, Ray Juncal |
| Previous by Thread: | Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle washers, Rfbegani |
| Next by Thread: | Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle washers, Rfbegani |
| Indexes: | [Date] [Thread] [Top] [All Lists] |