Simon - probably easier to slide the vacuum pipe nut away from the flare on
the pipe and use a short piece of rubber hose slipped onto the flare and the
push-on fitting on the dist. My BJ8 ran that way for 20 odd years - someone
before me had changed the threaded advance unit out for a push on unit.
Never had any problems with anything leaking. It was recently put back to
original with the full restoration.
Earl Kagna
Victoria, B.C.
BJ8, BT7 tri-carb
-----Original Message-----
From: Simon Atkinson
Sent: Monday, December 02, 2013 6:46 AM
To: healeys@autox.team.net
Subject: [Healeys] Petronix distributor
Seems that the vacuum unit is not threaded to connect to the line that goes
to
the carbs. I'm guessing best way is to find and adapter and thread the
vacuum
"nipple" on the distributor?
Thanks,
Simon
Cell 860-324-0248
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|