I have had the both races successfully reground. The machine shop will probably
have to remove the worm from the shaft, but that isn't terribly difficult. I
had it done so long ago, I don't remember if they took the shaft off or not. I
just handed them the worm with the shaft on it.
Ken Freese
65 BJ8
----- Original Message -----
From: "richard mayor" <mayorrichard@hotmail.com>
To: "healeys" <healeys@autox.team.net>
Sent: Saturday, October 12, 2013 12:07:10 PM
Subject: [Healeys] steering box worm gear repair
I have a steering box out of an early 3000. The only problem is that the
upper and lower bearing races on the worm gear are pitted. Has anyone found a
fix so I can use salvage this box?
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|