I think on the 100 if everything lines up properly, the original mount works
just fine. The BJ8 system, however, is such a snug fit and requires force to
fit properly, this option is needed! I use reinforced exhaust straps but
admittedly this looks more original.
I used this same mod on my Jag Mk IX, the exhaust system weighs as much as a
baby elephant.
Alan
On Jan 14, 2013, at 4:58 AM, "Larry Varley" <varley@cosmos.net.au> wrote:
> I have fixed a few with a less than ideal solution for friends who want to
> retain an original look, by drilling through the mount and fitting a
> countersunk screw from the rear, tapped through the front plate, then
> riveted over and dressed off flush. I haven't noticed any extra vibration
in
> my 100, and seems to also be fine in a friend's BJ8. Link to an image of
the
> modified mount below.
>
> Cheers
>
> Larry Varley
>
> http://www.acmefluid.com.au/larry/mount.jpg
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|
