There appears to be a lot of debate about the value of soldering crimped
connections. Soldering limits corrosion and in theory should provide a lower
resistance connection than well done crimping alone. I guess it depends on
how well the fabricator limits vibration stress at the connection. Your
technique should do the trick.
-----Original Message-----
From: Oudesluys [mailto:coudesluijs@chello.nl]
Sent: Friday, February 04, 2011 12:17 PM
To: Hap Polk
Cc: 'Richard Ewald'; healeys@autox.team.net
Subject: Re: [Healeys] BN2 80/100 W bulbs on the PL700 tripod headlights....
Hap,
I do often solder the connectors. To minimize fatigue fracture I fix the
first few cm's of the soldered wire to the body/engine etc. to prevent
flexing. This is adequate against fracture
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|