Guys.
I think you will find it is 7/16" square and therefore a ground down 1/2"
breaker bar will do the job perfectly.
I use a 3/8" drive to 1/2" drive converter which I have ground down and it
takes up no more room in the travelling kit than a socket.
_____________________________________________
(______________ Alan Bromfield _______________)
(______ \____1957-BN4____/ _______)
(_________________________)
http://tinyurl.com/healeyforum
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Danny Eskenazi
Sent: Wednesday, October 20, 2010 1:25 PM
To: healeys@autox.team.net
Subject: [Healeys] I give up: how do I remove the differential drain plug?
Greetings,
I replaced the front seal in my BT7's differential and I thought topping it
off would be the easy part. Turns out not so! Some googling has revealed
that it is a 7/8" square drive plug. The only advice I've seen is to make my
own tool by grinding down a 1/2" drive extension to fit. Well, I don't have
a grinder. Surely there's an easier way? Doesn't SOMEONE make a tool for
this?
Thanks,
-Danny
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|