I purchased a Burlen Electronic Conversion Fuel pump kit from Burlen
in the UK. This was to convert the original BN7 fuel pump.
However the bushing they furnished for the Diaphragm shaft was too
large for the hole in the core.
I decided to install the kit on my spare AZX 1300 Series pump.
After installation the pump refused to to cycle. As I pushed the
"hall Shield" in , per their instructions the pump would
buzz but not cycle.
On Jan 10 I sent them an Email explaining the problem. No response.
On Jan 24 I sent another, "any body home?" No response.
On Feb 1 I sent another," IS IT YOUR INTENT TO IGNORE ME?" No response.
Great Customer Relations.
Any one else had this problem?
Dave & Daisy BN7 II
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|