To allow improved distribution of the grease, upon the suggestion of local
AH club members, when rebuilding the front suspension on my 1959 BT7, we
installed grease fittings on both the front and rear trunnin bushings. One
just buys two front bushes instead of a front and rear. The Concours
judges missed this.
Ron
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Rich C
Sent: Sunday, October 18, 2009 12:33 PM
To: healeys@autox.team.net; Stephen Hutchings
Subject: Re: [Healeys] King pin lubrication
Stephen,
The lower portion of the king pin is drilled hollow for the grease fitting
on the very bottom to push the grease up inside the kingpin and out the
grease hole of the pin to the lined up spiral grease channel in the lower
bushing.
To review, there are 3 grease fittings per kingpin assembly. one to the
upper bushing, one (as above) from beneath, feeding up thru the pin to the
lower bushing, and the third being into the end of the lower trunnion. I
always assemble these lower trunnin bushings so the grease fitting is on the
forward one, an easier loaction to reach all the grease fittings from one
position. I also make sure the top and bottom fittings are 45 or 90 degree
ones so the nipples all face forward.
Rich Chrysler
----- Original Message -----
From: "Stephen Hutchings" <s.hutchings@rogers.com>
To: <healeys@autox.team.net>
Sent: Sunday, October 18, 2009 12:25 PM
Subject: [Healeys] King pin lubrication
> This has probably come up before, and I have a vague memory of someone
> complainig about it, but here's my question:
> How the heck is the lower kingpin bushing lubricated, other than upon
> assembly? Is the grease suppposed to dribble down from the upper bushing?
> Intuitively, one would expect another grease fitting.
>
> Stephen, BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|