Think I'd try to determine why the original clamps alone aren't working;
beefier
clamps aren't necessarily the best solution. Are the pipes out of round?
bs
Dan wrote:
> I have a 1963 BJ7 and am struggling with the clamps where the exhaust enters
> the muffler. Originally I had leaks in this area and decided to try and
> silence the leak. Someone on the list suggested using Stainless Steel plumbing
> repair couplings without the rubber insert. I installed those and reinstalled
> the standard muffler clamps over those. Everything works great except that
> when I start the car the exhaust hits the frame and makes a banging noise.
> When the car is running everything is fine.
>
> Having been cursed with being a perfectionist I want to eliminate the
> banging. Does anyone have any suggestions on a good clamp that is wide enough
> to seal the joint, probably 3/4"-1" and has good clamping capacity?
>
> On another note, Barrett Jackson Las Vegas is next weekend. Even though the
> prices resemble a Monopoly Game, the bidders are more in tune with Healeys
> than the ones that go to Mecum. Before we succumb to the low prices everyone
> is concerned with, it will be interesting to see what happens next weekend.
> There are currently 4 Healeys to be auctioned.
>
> Dan Serrao
> 1963 BJ7
> Fountain Hills, AZ
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|