Hi Tom-
The shroud should readily fit in place. Is this h=the original shroud?
There are adjustable tabs, or brackets on the top of each of the front
wheelwells. One on the brackets, is screwed to the opening of the hod
(bonnet), and the other rests along the inside of the lip of the side of the
shroud flange where yhe third bolt from the front passes through the shroud
and wing. They are adjustable via loosening the two bolts that pass through
them. If these tabs are too high, it can prevent the shroud from shroud from
lowering.B
Are the holes lining up at the front of the hood (bonnet) opening where the
countersunk screws pass through radiator support? that's the tell here- if the
shroud does not line up in this area, you know there is something hanging up
the shroud from lowering into its position.
Good luck.
Tom
[demime 1.01d removed an attachment of type image/jpeg which had a name of
IMG_0008.JPG]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
IMG_0013.JPG]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
IMG_0011.JPG]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|