healeys
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Healeys] Non-healey part

from [Taylor, Todd S] [Permanent Link][Original]
To: Healey list <healeys@autox.team.net>
Subject: [Healeys] Non-healey part
From: "Taylor, Todd S" <todd.s.taylor@lmco.com>
Date: Fri, 24 Apr 2009 11:11:32 -0400 
I was replacing my MGB's front crank oil seal and found that the crank
pulley broke it to 2 pieces.

The damping rubber I guess is shot.  Does any one out there have a good
used pulley for a 1980 MGB 

1.8 engine??   I found a few places that will rebuild it.   Can't finish
my project until I get this replaced...

  Thanks ..
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [Healeys] Tri Carb setup on Ebay, Geatros
Next by Date:  [Healeys] brake servo installation take 2, Richard Korn
Previous by Thread:  [Healeys] Tri Carb setup on Ebay, Geatros
Next by Thread:  Re: [Healeys] Non-healey part, Oudesluys
Indexes:  [Date] [Thread] [Top] [All Lists]