Hi Wes,
I would say definitely not. Although the bottom of the block would probably
fit between the frame rails the bell housing and back plate are far too
wide.
Michael Salter
-----Original Message-----
From: healeys-bounces+msalter=precisionsportscar.com@autox.team.net
[mailto:healeys-bounces+msalter=precisionsportscar.com@autox.team.net] On
Behalf Of Weston Keyes
Sent: Sunday, June 15, 2008 10:15 AM
To: healeys@autox.team.net
Subject: [Healeys] Engine installation
Hello Folks,
Is it possible to install a BJ8 motor and gearbox/overdrive unit from
the
bottom of the car. This assuming the manifolds, water pump etc are off the
block first.
Thanks
Wes Keyes
York, Maine
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|