healeys
[Top] [All Lists]

Re: [Healeys] BJ7/BJ8 door question

To: "John Vrugtman" <javrugtman@htcnet.org>
Subject: Re: [Healeys] BJ7/BJ8 door question
From: "Alan Seigrist" <healey.nut@gmail.com>
Date: Sat, 9 Feb 2008 08:58:43 +0800
John -

You can't use a BJ7 door on a BJ8 because the spindle on the window winder
isn't long enough.  What this means is the BJ8 door panel won't fit on the
BJ7 door - well actually it will fit but you won't be able to fit the window
winder on the winder shaft, unless you don't mind one door panel looking
totally different than the other door then it doesn't matter.  You won't be
able to fit the longer shaft BJ8 window winder on the BJ7 door because
there's not enough space between the window winder mount and the door skin
to fit the long shaft, it won't go in.

Alan

On Feb 9, 2008 7:16 AM, John Vrugtman <javrugtman@htcnet.org> wrote:

> Has anyone installed a BJ7 door on a BJ8 and if so what were the
> problems with the interior panel?  I have an new original BJ7 door and
> would like to install it on a phase I
> BJ8.  The only differences seem to be around the interior flanges,
> counter sunk for the BJ7 door pocket, but there is also a difference in
> the inside face on the hinge side.
> Any thoughts?
>
> John
> BJ8s
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>