I thought I had a good photo of a BN6/7 rear access panel installation, but I
can't find it. Can someone please tell me how the two hinges are attached to
the panel & the rear shelf. If screws, what type of head was used. Also, which
side of the hinge was up? I.E. was the hinge pin up or down? Up seems more
logical, but it creates a bump which would cause the Hardura (SP?) to wear
quickly in this area. Finally, I ordered some replacement hinges, but they seem
rather large for the application. I would appreciate receiving dimensions of
the
original hinges.
Thanks,
Gary Hodson
|