Here are the front wheel bearing numbers that I have for Timken right off of
the boxes. One box is a "set", (race and bearing). It just says " Set
6".
The other bearing and race set is in 2 separate boxes. The bearing is 07087
(with small number underneath, 200507 99). The race is 07196 (with small
number underneath, 200505 99). These numbers seem to correspond to
exactly what you read off of your units, Simon.
"Set 2 " will not fit the earlier 3000 cars as some of us are finding out.
These seem to be for the later cars when they switched to the course thread
hub adapter, maybe, don't hold me to that deduction but it would make sense.
Mark
----- Original Message -----
From: "Simon Lachlan" <simon.lachlan@homecall.co.uk>
To: "'healeyhelp'" <healeys@autox.team.net>
Sent: Wednesday, November 30, 2005 3:43 AM
Subject: Tmken bearing
>I bought some front wheel bearings on eBay about 2 months back. I've
>finally
> got round to doing the job. I find that the smaller of the two is too
> small.
> It is
>
> Timken bearing no.LM11949 with race no LM11910. The (correct) one I
> removed
> was Timken no. 07087X bearing with race no.07196.
>
> Have I got the bearing from an earlier or later 3000?...I may be able to
> swap, if I can identify. Or can anyone say what that bearing's application
> is?
>
> (The bigger bearing, race and oil seal were all fine)
>
>
>
>
>
> .
>
> .
>
>
>
> Simon.
|