Hi Scott,
I recently installed three point inertia reels in my BN2. I fixed the shoulder
mount to the side of the inner wheel wells fairly low down, to minimize the
interference of the folded down top with the inertia reels. I got the belts
from Norman Nock who was most helpful in providing mounting advice. You didn't
say if your belts are inertia reel. If they are, you need the type that can be
adjusted so the internal ratchet arrangement is verticle or horizontal, even
with the reel mounted at an angle. Again with advice from Norman, I got a
"wrap" of material made that fits around the folded down top. This pulls the
top into a tight bundle and allows the inertia reels to run freely underneath.
Mike
Date: Sun, 27 Mar 2005 14:22:25 -0600
From: "scott willis" <ahpowered@hotmail.com>
Subject: BN7 Seatbelt Installation?
Hi all,
I have a 3 point hook system I am putting in. I found where I plan to
drill
in the floor but I am not sure where to bolt the shoulder strap mount.
Should I mount it on top of the inner wheel well? Or should I mount it
on
the side of the rear wheel well? Any other suggestions? I am affraid to
damage any of the vinyl covered wood.
I'm this close to safety!
CHeers,
Scott
Mashed BN7
|