Ben: No! You really need to get a BN2 wiring diagram. Even though the OD
components are largely the same as BN1, they are wired entirely different.
You will find one in the workshop manual which has the BN2 supplement, or
you can use the 100-6 or early 3000 wiring diagram. Let me know if you
can't find one, Ill try to scan it and email it to you.
Jim
----- Original Message -----
From: "Ben Prince" <blprince2@comcast.net>
To: "Bluechipracing" <bluechipracing@snet.net>; "Healeys"
<healeys@autox.team.net>
Sent: Saturday, March 12, 2005 9:53 PM
Subject: Re: BN2 Overdrive
> Jim,
>
> Per your comments, to convert the BN1 overdrive wiring to the BN2, here is
> what appears to be needed.
>
> I have a BN1 wiring diagram, but don't have one for the BN2.
> I assume that the two wires on the centrifugal switch should be removed
> from
> the switch and then connected together. Also, it looks like the coil
> leads
> on the R2 relay should be disconnected from the relay and joined together.
> And I assume that the other wires on the R2 relay should be disconnected
> and
> the relay removed. Is my understanding correct?
>
> I haven't actually decided on making the BN2 conversion, but I am curious
> about what would be done.
>
> Many thanks,
> Ben
> .
>
> ----- Original Message -----
> From: "Bluechipracing" <bluechipracing@snet.net>
> To: "Ben Prince" <blprince2@comcast.net>; "Healeys"
> <healeys@autox.team.net>
> Sent: Wednesday, March 09, 2005 6:40 AM
> Subject: Re: BN2 Overdrive
>
>
>> Ben: Simply rewire the od and its control components using one relay
>> according to the BN2 wiring diagram. You can do this without removing or
>> relocating any of the components but you'll bypass the centrifugal switch
>> (which IMHO is worthless anyway).
>>
>> However, why bother if everything is functioning ok. Except for the
>> centrifugal switch, the operation is the same.
>>
>> Jim
>>
>> ----- Original Message -----
>> From: "Ben Prince" <blprince2@comcast.net>
>> To: "Healeys" <healeys@autox.team.net>
>> Sent: Tuesday, March 08, 2005 2:25 PM
>> Subject: BN2 Overdrive
>>
>>
>> > My BN1 has two overdrive relays. According to Clausager's book, the
>> > BN2
>> > had
>> > only one overdrive relay and the wiring was simplified.
>> >
>> > How do I switch my two relay BN1 to the BN2 set-up?
>> >
>> > Thanks,
>> > Ben
|