Re: Engine & drive train alignment -Tri-Carb Jet Clearance

[john spaur <jmsdarch@sbcglobal.net>]

John,

How does one adjust the clearance so that the jet does not rub on the 
steering column? It is so close on my healey that I have had to file the 
plastic; yuck! The only way I see is to raise the engine. I have new rubber 
mounting pads. Are there different motor mount heights between the car models?

John

At 06:01 PM 2/20/05, John Snyder wrote:
>My only comment is that if your BN7 is a tri-carb, be very careful of the 
>clearance between the bottom of the rear carb jet (plastic) and the 
>steering column.
>
>John Snyder