healeys
[Top] [All Lists]

Re: Splash Apron Confusion

To: "Dave & Marlene" <rusd@velocitus.net>,
Subject: Re: Splash Apron Confusion
From: "Rich C" <richchrysler@quickclic.net>
Date: Fri, 25 Jun 2004 21:09:38 -0400
Hi Rick,
Dave is pretty much right on in his description.
The crease in the front shroud panel should not be there. The two buffer
pieces preventing direct contact between painted valance and bumper inner
edge are a dark tan, dark brown or dark red sort of coloured rubber, 11/32"
diameter and were not painted.
The pan head phillips screws were backed up by flat washers, lock washers
and nuts.
Hope this helps.
Rich Chrysler

----- Original Message ----- 
From: "Dave & Marlene" <rusd@velocitus.net>
To: "Rick Neves _._" <Rick@genomictechnologies.com>
Cc: "Healey list" <healeys@autox.team.net>
Sent: Thursday, June 24, 2004 8:27 PM
Subject: Re: Splash Apron Confusion


> Hi Rick,
>
> I'll give it a try just to get you started on the right track. Rich C.
> or Mike S, or Curt A. or ? will likely add more details.
>
> The BN2 apron is completely different than the 3000's. It bolts up tight
> against the shroud & extends forward nearly to the bumper inside corner.
> The apron is mounted to the shroud with 10-32 pan head Phillips screws.
> A black solid vinyl welt of 1/4" diameter goes between the two. The
> outer (bumper end) screws had the heads on the inside, the rest on the
> outside. Where the apron fits under the bumper edge there are two
> plastic bumpers in it to prevent contact between bumper  & apron. On my
> BN2 the apron is aluminum. The crease may have been to allow for driving
> light wiring to pass through.
>
> Dave Russell
> BN2
>
> Rick Neves _._ wrote:
> > I am beginning to do the final fit of the body panels on my BN-2. I
received a
> > new front splash Apron from Moss. This vehicle didn't come with one. I'm
> > wondering how the Apron fits on the car. I had the opportunity to view a
> > couple of 3000's last weekend and it appears that the apron does not go
up
> > against the front shroud but stands off it about 1 inch.
> >
> > My front shroud has a crease in it right where the apron would go
across. I
> > thought this was either from being pushed in due to an accident or that
the
> > apron fit tight in the crease. There is also a couple of holes in the
shroud,
> > like may be the splash apron bolted into those positions. Moss also has
listed
> > in the assemblies "Piping for the front apron on a 100-4 but I don't see
any
> > for the 3000. And there are two different part numbers for the two
aprons.
> >
> > So does anybody know if the front apron on a 100-4 is up tight? (against
the
> > shroud!)
> > AND, Should the front shroud have a crease? Or should I flatten that
out?
> >
> >
> > Sincerely
> >
> >
> > Rick Neves
> > '56 BN-2





<Prev in Thread] Current Thread [Next in Thread>