Hi Greg,
I have one of those cone shaped front suspension bumpers mounted above the
center section. I trimmed it down a little to give more travel. I placed a
short length of leaf spring between the bumper and the floor to spread the load
if contact is made. I'm not sure it has made contact. I changed the springs
from 1.5" de-arch to 1" at the same time. With the 1.5" de-arched springs, the
axle was making contact with the floor, especially when I had a passenger. The
main problem was that the pinion flange was touching the tunnel. You could
probably use them where the axle tube might contact the body at the wheel well
to floor seems too.
Dave H.
> On 10/14/2024 5:48 AM PDT Greg Blake via Fot <fot@autox.team.net> wrote:
>
>
> What are the TR3/TR4 racers using for a bump stop on the rear suspension? My
> car is lower significantly and still using lever shocks. just wondering what
> others are using to limit suspension travel in bump.
>
> Greg
>
>
> Sent from my iPhone
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/dlhogye@comcast.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
|