[Fot] Thrust Bearing fabrication question?

[David Cutter via Fot <fot@autox.team.net>]

--===============2992081222442679500==

--0000000000005fbef405f55fadfd

Amici, fabricating some full 360 degree thrust bearings for the first
time.  What is the recommended method for fastening them?  Pin or other
fastener?  Fasten both halves or just the upper half?

Thanks!
Dave
Spitfire #42

--0000000000005fbef405f55fadfd
Content-Transfer-Encoding: quoted-printable

<div dir=3D"ltr">Amici, fabricating some full 360 degree thrust bearings fo=
r the first time.=C2=A0 What is the recommended method for fastening them?=
=C2=A0 Pin or other fastener?=C2=A0 Fasten both halves or just the upper ha=
lf?<div><br></div><div>Thanks!</div><div>Dave</div><div>Spitfire #42</div><=
div><br></div><div><br></div></div>

--0000000000005fbef405f55fadfd--

--===============2992081222442679500==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot



--===============2992081222442679500==--