Hi Brian, as an old friend told me, and from personal experience, you have
about a 50-50 chance of success when rebuilding these.
For my 2 cents, I'd buy two of the less expensive ones, put one on the car and
the other for spare. Or buy the more expensive one to put on the car and the
cheaper one for spare.
You might want to replace the slave too while you're at it.
Also from my experience, trying to save a few bucks and go the cheaper route
usually bites you in the butt.
Also on my TR6, there was kind of a plastic line going to the slave. It's been
replaced by a braided line yrear ago. Cheap insurance.
Good luck.
Bill----- Original Message -----
From: Brian Schirano via Fot
To: FOT
Sent: Thursday, May 03, 2018 10:46 PM
Subject: [Fot] clutch master opinion
Hey Guys
I need to replace my clutch master cylinder then rebuild the old one as a
spare. Quick opinion survey for GT6 clutch master cyl mfg
TRW PNB454 $91 at BP Northwest
or
Beck/Arnley 072-1308 ~ $51 Rock Auto or Amazon
Or?
Thanks
Brian
26A GT6+, 28 TR6
Brian Schirano
585-305-0349 Cell
BSchirano at yahoo.com
------------------------------------------------------------------------------
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/william.tobin31
at verizon.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180504/f9022327/attachment.html>
|