Thanks...I AM polishing the jet tube to a fine finish. I read that somewhere,
sometime.
Sent from my iPad
On Jun 10, 2013, at 8:33 PM, Duncan Charlton <duncan.charlton54@gmail.com>
wrote:
> Joe,
>
> I didn't do anything special when replacing all the seals on a set of H6's
but
> if you want those jet tubes to slide smoothly through the cork seals, you
> might try Hylomar, which never hardens, and fuel is unlikely to flush it
> away.
>
> Duncan
>
>
> On Jun 10, 2013, at 7:22 PM, Joe Alexander wrote:
>
>> It's been 25 years since assembling a set of TR3A carbs.
>>
>> Any favorite assembly lube for cork seals, caveats, etc.?
>>
>> Thanks.....
>>
>> Joe A.
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/n197tr4@cs.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|