fot
[Top] [All Lists]

Re: [Fot] TR4 camshaft bearings & clearances

To: "'Randall'" <TR3driver@ca.rr.com>, <fot@autox.team.net>
Subject: Re: [Fot] TR4 camshaft bearings & clearances
From: "Alexandre Camoletti" <ac@camoletti.ch>
Date: Wed, 1 Jun 2011 19:41:47 +0200
Thank you Randall, I must have been tired when checking out.
in fact VIZARD recommends to go for clearances at the lowest end (while for
a race engine one would tend to go for the larger clearances), to ensure
timing precision

-----Message d'origine-----
De : fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] De la
part de Randall
Envoyi : mercredi 1 juin 2011 19:18
@ : fot@autox.team.net
Objet : Re: [Fot] TR4 camshaft bearings & clearances

> I found these figures  in David Vizard, Tuning Triumphs over 1300cc,

The same figures (pretty close) can be found in the factory TR2/3 workshop
manual, page B3 (or page 87 of the Bentley reprint).

-- Randall
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/ac@camoletti.ch
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>