I had used self made plain copper, copper with wire. They didn't last, half
a race and the water was gone.
I moved on the crimped steel shim gaskets, sold by Bastuck or Racetoratios.
Both do well but after 2-3 events I have to change them.
I also had an interest at Cometic, but the gasket is too thick, about 0.047"
instead of the steel shim thickness of 0.0236".
It seems that this gasket won't fit my engine.
Cheers
Chris
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von n197tr4@cs.com
Gesendet: Donnerstag, 28. April 2011 01:17
An: fot@autox.team.net
Betreff: [Fot] headgasket approaches tr3 tr4 a brief summary. fyi
1. OEM style gasket
2. OEM style gasket with copper wire in liner groove
3. Steel shim gasket with copper wire
4. Steel shim gasket w/out any wire.
5. Copper gasket with steel wire in head groove.
6. Cometic gasket
Gasket dressing varies
We have done most all with reasonable success....except Cometic.
Surprised at limited number of responses..... and the variety of solutions.
Perhaps gasket sealing is a non issue or everyone is busy changing head
gaskets.
It appears that OEM style is understandably the most forgiving, but concern
remains that it might not work well with the typically modified head.
Joe A
I suppose we should assume that all surfaces and assemblies are in spec.
I'd like to see a Cometic and try it...we have one on order but will not
receive it in time for this engine assembly.
Anyother comments.....??
=
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/tr4racing@googlemail.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|