I slip in the sleeves by hand, no tools required.
Then I install the head give about 80 percent of the toque on the head nuts.
After that I measure the protrusion.
Cheers
Chris
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von Mark Pendergrass
Gesendet: Mittwoch, 20. Mai 2009 16:13
An: friends of triumph
Betreff: [Fot] setting sleeves/barrels
FoTrs; I realize i am probably beating a dead horse to the majority of you
on
this subject, but what is the proper seating pressure one should aim for
when
setting the sleeves into the block to measure the deck to liner clearance.
Do
you let the sleeves set naturally on the figure 8s with slight pressure or
no
pressure or ???......Thank You in advance. Trying desperately for Rose Cup
in
June. Mark Pendergrass (Pendy) tr4 #65
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|