Thanks Charly (M)...(the lottery winner)
Chuck (A) asked about this, I believe.
If there is enough interest, the FoT et. al may provide an acceptable mock up
that we can reverse engineer and cost it out.
Jack Drews did the TR3/TR4/TR4A Heat Shield and I modified it. Irv Korey had
the pattern for the TR6 and I modified it as well. Both are proving to be
very, very good projects. Far more than I anticipated.
If we can get a little organized...depending on the complexity, it might be
possible to produce as few as 5-10 units and still be attractive costwise with
our manufacturing processes.
I'd rather not produce less than 25, but would consider it.
The best possible template, prototype, mock up with a little potential for
volume would get the most and fastest attention. Back to you guys...this could
be fun. There is a lot of talent in this list.
Joe (A)
> Joe, I know there might not be much need for this, but how about a heat
> shield for PI? It might be similar to the triple Weber setup.
> Charly
> TR6 #44
|