In a message dated 6/25/05 6:18:42 PM Pacific Daylight Time,
jaboruch@netzero.net writes:
<< When I put the cover onto the head I coat the gasket or the head with some
oil and then assemble it. The oil allows me to easily remove the cover when
I need to. I have had the same gasket on the valve cover for years, with
minimal if any leakage. Joe(B) >>
I thought that we were not allowed to talk about putting oil on valve cover
gaskets!
I made the last double regional at Nelson Ledges. Towards the end of the
first race, the frame started dragging on the asphalt through the right hand
bends. I then pulled off of the track and didn't run the Sunday race. Since I
was far enough ahead of a sick EP BMW, I still finished in first.
|