Re: Moldex Crank, Bearing width, Rods

[BillDentin@aol.com]

In a message dated 08/26/2004 9:14:09 AM Central Daylight Time, 
Richtr@erols.com writes:


> OK so we build a crank that last and rods that don't break. Now what block 
> are
> we going to put it in?
> 

In the early 1990s, as each new tweak came up, Mike Belfer would say, "The 
block is the next weak link!"  Bob Tullius gave Mike a tip one time, and Mike 
said, "The block can't take that!"  Bob's answer was something like, "It can 
for 
twenty-five minutes."

Bill Dentinger


Bill (Damdinger)