TR3-4 dist question

[TeriAnn Wakeman <twakeman@cruzers.com>]

I guess I asked this question when everyone was off at a race.  I'll 
try again.

For a TR3-4 distributor

I'm looking for the diameter of the lock pin hole in the lower 
distributor shaft.  The one that holds the drive gear in place.

Also the distance between the bottom of the distributor shaft and 
centre point of the hole.

Thanks

T. J. Wakeman
Santa Cruz, California
  http://www.cruzers.com/~twakeman

A member of the internet community since 1985.