The hubs work on TR3 through TR6. Same hub. I don't think they do any
internet stuff (like e-mail), but are geniuses with machine tools and
design problems. I show their contact info as:
SOUTHWICK MACHINE & DESIGN
21300 BRIAR BLUFF RD
COLONA, IL
(309)949-2868
- Tony Drews
At 02:32 PM 8/23/2003, Bill Babcock wrote:
>I presume these also work on TR3/4 since I don't recall any difference
>between tr3 and tr6 hubs. Yes?
>
>Does anyone have an email address handy for southwick?
>
>-----Original Message-----
>From: Tony Drews [mailto:tony@tonydrews.com]
>Sent: Saturday, August 23, 2003 11:36 AM
>To: fot@autox.team.net
>Subject: Re: TR6 alloy front hubs available
>
>
>Picture of the kit is at http://www.tonydrews.com/hub_kit4.jpg . No
>financial interest, but I'm happy with my set.
>
>- Tony Drews
>
>At 11:41 AM 8/23/2003, SHANE Ingate wrote:
> >All,
> >
> >This just in. Southwick Machine are making a run of front alloy hubs
> >for the TR6, including Timken bearings etc. If you need a set, better
> >call Bob at 309-949-2868 because I think that all the hubs in their
> >current run may be accounted for, but I am sure they will add more if
> >asked. The current run is being made over the next 5 days, and once
> >the dies are removed, they stay off until a minimum order number is
> >reached; the wait between production runs is long.
> >
> >This is not an endorsement for Southwick Machine, as I have not had any
> >experience with their products. I have ordered a pair of hubs, so I am
> >about to find out first hand.
> >
> >If someone could cross-post this to the 6-Pack list, I think some folk
> >there may find this news interesting.
> >
> >Shane Ingate in Maryland
> >
> >_________________________________________________________________
> >MSN 8: Get 6 months for $9.95/month
> >http://join.msn.com/?page=dept/dialup
|
