In a message dated 4/15/2001 9:52:16 AM Eastern Daylight Time,
marshall@nefcom.net writes:
> Assuming it
> is, is this something that any decent machine shop can do correctly or do I
> need a specialist of some kind? Would your typical engine rebuilding shop
> be able to do it correctly? Can I do it at home with my trusty die grinder?
>
A good question to ask your decent machine shop guy, I'd say...
"If it's not fun why do it?" Jerry Greenfield
Clark W. Nicholls
CWNicholls@aol.com
http://members.aol.com/CWNicholls
fax: 419-844-7564 (yes, 419)
phone: 413-243-3433
|