In a message dated 4/27/00 11:45:10 AM Pacific Daylight Time,
jwheeler@seidata.com writes:
<< Bill, Dick was one of the people who suggested I go back to stock pistons
and bodies. The carbs he did for me were on the car when I won the
runoffs, and they had stock (unmodified) pistons & bodies. Based on my
experience and the flow bench work Dick did, I strongly recommend this
setup. >>
I appreciate the information Jack. After thinking about it, rounding off
pistons in the front may have a tendency to force and compress the inlet air
down lower in the flow path, and therefore possibly reduce the overall mass
flow rate. I will look for some stock pistons in my piles. I assume you
removed the dash pot pistons and oil so that the primary pistons fly up
instantly upon acceleration? Thanks again.
|