Hi Bob, I had a cam seize in the block several yrs. ago. in the GT-6. I
got
cam bearing from Ken (BFE) and had them installed here in Denver, cost
was around $250. Most any good engine builder should have a shot -peener.
Dan
SDS Racing
----------
> From: Bob Lang <LANG@ISIS.MIT.EDU>
> To: triumphs@autox.team.net
> Cc: fot@autox.team.net
> Subject: Align Boring for Cam Bearings
> Date: Friday, November 13, 1998 10:02 AM
>
> Hi All,
>
> I'm performing a sanity check:
>
> TR engine block - align boring for cam bearings...
>
> I got a price of $375 for the job.
>
> It sounds high... can anybody provide numbers that support this price???
>
> Oh, and I'm looking for someone to shot-peen some TR6 rods. Any pointers?
>
> C ya,
> rml
>
----------------------------------------------------------------------------
---
> Bob Lang Room N42-140Q | This space for rent.
> Consultant MIT Computer Services |
> Voice: (617)253-7438 FAX: (617)258-9535 |
>
----------------------------------------------------------------------------
---
|