datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] leaking steering box question

To: Stephen Holst <stephen.holst@randrglobal.com>
Subject: Re: [Roadsters] leaking steering box question
From: Linda J <ljordan704@netscape.net>
Date: Fri, 5 Jul 2013 08:33:38 -0700
Cc: "<datsun-roadsters@autox.team.net>" <datsun-roadsters@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: datsun-roadsters@autox.team.net
References: <CDFC58E2.5122%stephen.holst@randrglobal.com>
Which Redline product did you use? I always thought synthetics leaked more.

Linda

Sent from my iPod

On Jul 5, 2013, at 8:05 AM, Stephen Holst <stephen.holst@randrglobal.com>
wrote:

> On My 1968 the steering box had gone dry and resulted in some loose
steering
> I refilled the box with red line synthetic that leaked slowly.  Every
couple
> of months I refilled.  Currently the seals seemed to have expanded and
there
> is only the occasional droplet.  While I am not of the opinion that
> mechanical things heal themselves I do believe that seals can be
> "re-hydrated".  Worth a try. If you do keep checking the levels if it
> maintains --saved a bunch of work.
> Steve
>
>
> On 7/5/13 12:27 AM, "Gary and Cindy Ault" <aultgc@att.net> wrote:
>
>> I assume your car is pre-1969, and therefore has a worm and roller (Type
A)
>> steering box, although I think a similar repair on a Type B box will be
>> pretty much the same.
>>
>> There is an oil seal on the bottom of the box where the shaft exists and
the
>> Pittman arm is attached.  Good chance that is the source of your leak.
>> Unfortunately, it is not easy to correct, as you'll need to 1) disconnect
>> the cross rod joint and tie rod end from the Pittman arm, and 2) remove
the
>> Pittman arm from the steering shaft.  Remove the top of the steering box.
>> Disconnect the steering U-joint and pull the steering column backward into
>> the car about six inches.  Remove the rear (traingular shaped) cover, and
>> withdraw the worm gear.  Then you can withdraw the steering shaft from the
>> steering box through the top of the box..  Pry out the seal and install a
>> new one, then put things back together.  That's what I recall without
>> looking at the exploded diagram.  You may be able to do all this with the
>> box in the car, but it's easier with the box removed.  That said, removing
>> the box with the radiator and all the other stuff up front in place was a
>> real bear.
>>
>> I once bought a used Type A box on eBay which was said to be tight and
have
>> no apparent wear in the worm gear.  The seller was correct on those
points,
>> but the box was not filled with gear oil as Nissan intended, but rather
was
>> packed with lithium moly grease.  That might have worked OK, but I cleaned
>> it out, and, presuming that the grease was put in because the lower seal
was
>> leaking and the owner didn't want to pull the box apart, I pulled the box
>> apart, cleaned out the grease, replaced the lower seal and installed it in
>> my '67-1/2 2000.  Works fine.  You could try the grease trick -- I'm just
>> one for keeping things the way the factory intended.  As long as you get
>> enough grease into the box to assure good pubrication between the worm
gear
>> and roller, it may work.
>>
>> If you want further discussion, contact me off List.
>>
>> Gary
>>
>> ----- Original Message -----
>> From: "Ed and Sandie" <edsandie@telus.net>
>> To: <datsun-roadsters@autox.team.net>
>> Sent: Thursday, July 04, 2013 4:45 PM
>> Subject: [Roadsters] leaking steering box question
>>
>>
>>> Hi there, well we finally have our cute little roadster on the road,
>>> learning
>>> a lot about this little car took it for our first fun drive yesterday so
>>> my
>>> husband could teach me the shifting etc, what fun!  But today I noticed
>>> something leaking under and behind the front drivers side wheel, my
>>> husband
>>> jacked the car up and it looks as though it is coming from the steering
>>> box.
>>> Now we did fill this up is it possible we over filled it or is there
>>> another
>>> problem we are soon to learn about!....
>>>
>>> Sandie
>>>
>>> [demime 1.01d removed an attachment of type image/png which had a name of
>>> wlEmoticon-smile[1].png]
>>> ________________________________________
>>>
>>> datsun-roadsters@autox.team.net
>>>
>>> Donate: http://www.team.net/donate.html
>>> Archive: http://www.team.net/archive
>>> Forums: http://www.team.net/forums
>>> Unsubscribe:
>>> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
>> ________________________________________
>>
>> datsun-roadsters@autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe:
>>
http://autox.team.net/mailman/options/datsun-roadsters/stephen.holst@randrglo
b
>> al.com
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/ljordan704@netscape.ne
t
________________________________________

datsun-roadsters@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: 
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>