Agreed. Make sure you sand the soldering iron "scar" flush so the float
doesn't hang up.
Sent from my iPad
On Jan 16, 2013, at 7:03 PM, Graeme Suckling <graemes@internode.on.net>
wrote:
> What can be done is plastic welding using a heat gun or as mentioned, the
tip of a soldering iron.
> Applied carefully it may easily seal the crack and add no further weight to
the float.
>
> Regards,
> Graeme Suckling
> http://tinyurl.com/6n5aza
> Adelaide
> South Australia.
>
> On 17/01/2013 10:04 AM, Linda J wrote:
>> Not if it's plastic.
>>
>> Linda
>>
>> Sent from my iPod
>>
>> On Jan 16, 2013, at 2:32 PM, Mark J Bradakis <mark@bradakis.com> wrote:
>>
>>> Wonder if the crack could be sealed up with a soldering gun?
>>>
>>> mjb.
>>> ________________________________________
>>>
>>> datsun-roadsters@autox.team.net
>>>
>>> Donate: http://www.team.net/donate.html
>>> Archive: http://www.team.net/archive
>>> Forums: http://www.team.net/forums
>>> Unsubscribe:
>>
http://autox.team.net/mailman/options/datsun-roadsters/ljordan704@netscape.ne
>> t
>> ________________________________________
>>
>> datsun-roadsters@autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/graemes@internode.on.n
et
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/jrusso07@rochester.rr.
com
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|