I am an idiot. plain and simple. just an idiot.
Why you ask? No reason. I am just an idiot. now I am going to have a
beer on a school night.
(I was looking at the wrong end of the bleedin thing)
It's a "B".
having a beer now. i'm an idiot.
On Wed, Dec 7, 2011 at 8:25 AM, Tim wrote:
> OK, one more piece of info needed here....
>
> This is supposed to be a reground cam so no "B" stamp.
>
> thanks
>
>
> On Wed, Dec 7, 2011 at 7:53 AM, Tim wrote:
>
>> I guess I might need to be more clear...
>>
>> I want to determine if 2000 cam I have is actually the "B" grind I
>> was told it was when I bought the head. So I need to measure for lift
>> and duration (right?) to determine the grind of this cam.
>>
>> Thanks!
>>
>> On Wed, Dec 7, 2011 at 6:10 AM, Tim wrote:
>>
>>> Can someone please send me a picture, drawing, diagram, hyrogliphic,
>>> .jpg, .gif, bitmap, etc that clearly shows where I need to put the
>>> micrometer in order to get an accurate measure of a cam shaft?
>>>
>>> A shot of a cam with the micrometer actually in/on the two spots
>>> needed to be measured would be greatly appreciated.
>>>
>>> Thanks very much!!!
>>>
>>> Tim
>>> ________________________________________
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/tputland@charter.net
________________________________________
datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|