datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] GPS speedo calibration

To: datsun-roadsters@autox.team.net
Subject: Re: [Roadsters] GPS speedo calibration
From: Kerry Dehmel <datsun67vette06@sbcglobal.net>
Date: Fri, 15 May 2009 13:33:43 -0700 (PDT)
I have an excel spreed sheet that you enter your gear ratio and wheel size info 
and it tells you you rpm and your speed.

I know that we can't attach a file on the list so email me off list and I will 
send it to you.

 
Kerry Dehmel
Fresno, CA
1976.5 Datsun Roadster -- 1600 Blue 
1967.5 Datsun Roadster -- 1600 Emerald green
2006   Corvette Coupe--  Montery red 




________________________________
From: Ronnie Day <ronnie.day@gmail.com>
To: Roadster List <datsun-roadsters@autox.team.net>
Sent: Thursday, May 14, 2009 7:24:02 PM
Subject: Re: [Roadsters] GPS speedo calibration

> So, how accurate is a GPS at displaying actual speed? I calibrated my
> roadster speedo to my GPS & it showed I was consistently at least 5 mph
> below at low speeds & 8-10mph below at highway speeds.
>
There's some lag as you speed up and slow down, but I'd run my car to
desired indicated speed on the GPS readout, hold it for a few seconds
until the speed readout settled down and then note the gear, RPM and
speed.

FWIW, I use M$ Streets & Trips 2009 with the USB GPS module on a
MacBook. I think it was around $70 at either Amazon or Buy.com. You
can usually get the software by itself for around $30. Very useful
tool for both what we're discussing as well as trip planning, etc, and
the display's a heck of a lot easier to read for us old farts. Then
again, a suction holder on the windshield doesn't work so well. <grin>

Ron
You are subscribed as datsun67vette06@sbcglobal.net

Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net  http://www.team.net/donate.html


Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

<Prev in Thread] Current Thread [Next in Thread>