Hello All,
I think that I am going to try this first. Smooth out the raised
area with a fine file and sanding block. I'm already sanding out the gouge
in the piston top from the screw that got sucked in.
I looked closer at the stud and I think that I am going to just try
to twist it out.
Now, does anybody have an useful opinion on my CR question???
Daniel Neuman
Oakland CA
69 2000
-----Original Message-----
From: andy cost [mailto:andycost@earthlink.net]
Sent: Sunday, June 11, 2006 5:02 PM
To: Daniel Neuman; datsun-roadsters@autox.team.net
Subject: RE: Head fell off the workbench am I screwed?
Unscrew the bent stud. You can probably sand out the raised area on the
head. You could probably have it milled but I think you can get it close
enough with a sanding block.
|