I am planning on installing some helwig helper springs on the roadster (67
1600) tomorrow. I was looking the instructions over. at one point it says to
lower the car and adjust height and load as necessary. I am not sure how I
supposed to do it. as far as I can tell it just bolts on. there is no
adjustment other than placement that I can see. it has the two leaf springs,
4 "U" bolts, brackets (to go along with the bolts), and 16 nuts. any tips
would be great.
thx,
mike
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|