I need help figuring out why I can't do a rough alignment of wheels after
reassembling front suspension pieces. I was just going to do a rough thread
measurement at front and back of each tire to set the wheels pointing ahead.
The last thing I did was start threading the steering link to each of the
steering arm and idler arm. The only thing I can think of is that when I
removed the steering box from the car to clean it up I had to remove the
top. I think the ball/rod part lifted out about three times. Could it have
slipped over a notch? Anyone. Thanks in advance. Larry.
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|