--- Adam Bradley <ambradley@yahoo.com> wrote:
> I have read that the hoods are the same dimensions but the hood prop
> may be different. Also, the latch on the '70 (and '69?) has a second
> release lever whose mounting holes may not be present on the earlier
> hoods.
>
> If you are willing to weld the hood prop on, you can probably get a
> different year hood to fit pretty well. Or drive without so everyone
> can admire your engine.
>
>
> --- "Patrick J. Horne" <horne@cs.utexas.edu> wrote:
> > I believe the 67.5 hood is unique unto itself. The earlier cars
> > had single break master cylinders which didn't need the recess in
> > the bottom of the hood, and the 68 and later cars had the hood
> > prop on the opposite side.
> >
> > Peace,
> > Pat
> >
> > - Support Habitat for Humanity, A "hand up", not a "hand out" -
> >
> > Pat Horne, Network Manager, Shop Supervisor, Future planner
> > CS Dept, University of Texas, Austin, Tx. 78712 USA
> > voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
> >
> > On Thu, 5 Jul 2001 Robert.Long@CSDInc.com wrote:
> >
> > > Dearest list,
> > >
> > > Does anyone have a good/clean hood that would fit my 67.5 1600?
> > Not
> > > sure if all years are the same or not???
> > >
> > > Hope you Shasta-ers have a blast.
> > >
> > > Robert
> > > 67.5 1600
> > > Abq
>
>
> =====
> Adam
> '70 1600 SPL311-28181
> http://www.picturetrail.com/abend
> Get personalized email addresses from Yahoo! Mail
> http://personal.mail.yahoo.com/
=====
Adam
'70 1600 SPL311-28181
http://www.picturetrail.com/abend
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/
|