Am installing the window and door hardware. Got to the point of putting in
the large door windows. Cut a strip of innertube rubber for the gasket
around the bottom of the window and was ready to install when I realized
that the window channel would fit onto the rollers either way. I know there
is a left and right side channel, I just do not know which is which. Does
the part that has the threaded hole for a stop screw go to the rear of the
door? That would put the longer track at the rear. Am I right on this? Don't
want to pry the windows back out of the channel--already did that taking
them apart!
Paul Bauman
Westminster, CA
67 1600
http://albums.photopoint.com/j/AlbumIndex?u=881168&a=6499541
|