In rebuilding my front suspension/steering I have a couple questions. I
ordered dust seals from one of the vendors and during the rebuild, I found
that I need clamps to hold the seals on. The fiche print I have only shows
clamps for the upper ball joint. Is none needed for the bottom and if so
does anyone have the part number?
Next, I have 2 Idlers Arm assm. and both are worn. Assuming the shaft is
not pitted, is there anything special about replacing the bushings? I
assume these will have to be pressed on at a maching shop, true? Anything
else I should know?
John Schmitt Telecommuter Office # - 847-458-7829
Internal phonemail only - 847-240-4725 pager pin# 800-759-8888
pin 8710561
|