My warped head is 4.517 with around .010 warpage. I too want to have the head
heat straightened and normalized. New seats and seals along with the checking
of the cam, valve guides, valves and other such things.
I need names and numbers of people who do this that are good and trustworthy.
I don't mind shipping the head (I live on the East Coast, NC). Do you guys
have suggestions.
Thanks
John
68 FairLady 2L
BTW isn't there a Frisby on the list???
In a message dated 3/3/99 1:20:57 PM Eastern Standard Time,
jvanslyke@ixpres.com writes:
> My head is 4.455" with .015 of warpage. The head thickness should be
> 4.528" thick, going by earlier posts.
>
> The machine shop will straighten it and then have to cut it down, upon
> which the cam tower shims will be necessary. The head needs to be welded
> in 14 places, all the valve seals are bad, and one seat is bad. But it
> checks out on the water pressure test.
>
|