--On Monday, April 19, 2004 8:55 AM -0400 "Colbert, Raymond J."
<Raymond.Colbert@alcoa.com> wrote:
> Who could afford to have a pan anodized? Having personally done this I
> would say it could cost as much if not more than the piece itself. A
> better solution is the green (Zinc/Chromate)primer that aircraft use that
> coats the inside of most if not all commercial jets. Then put an anti
> wear layer over that. Do not wory about the oxide growth it will stop if
> you stay out of the salt and keep disimilar metals (ie steel)
> electrically separate.
Ray,
Can you name products for the primer and anti-wear layer?
Does "keep dissimilar metals electrically separate" mean that I can't use
the frame/floorpan assembly as ground?
Mark
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/autox-cm
|