According to FF1600 your best bet for getting the machining done is to
either send the flywheel to a "name" FF engine builder or to buy a new one
from a name FF engine builder. In any case, make sure that the ring gear
tooth count stays the same if you get a new ring gear.
Dick
At 06:15 PM 10/29/2003 -0500, tyson@irobot.com wrote:
>A month or so ago, fast track seemed to indicate that the official
>min-weight for flywheels is now 15.5 lbs.
>
>Any suggestions to not do this?
>
>Any suggestions about how/where/who to have the work done to the flywheel?
>
>I really don't have the resources for upgrades to the car, but this one
>should be cheap (though a minor annoyance).
>
>Thanks!
>Ty
>
>--
>Tyson D Sawyer iRobot Corporation
>Senior Systems Engineer Military Systems Division
>tsawyer@irobot.com Robots for the Real World
>603-654-3400 ext 206 http://www.irobot.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/autox-cm
|